This website uses cookies to enhance your experience.

Mitre-Fastening Set 8,

Item No. 0.0.492.30
0 reviews Write a review
Mitre-Fastening Sets are suitable for connecting two aluminum extrusion profiles at an angle. They are used primarily when constructing frame elements and panel edging. The profile grooves facing each other inside the frame remain unobstructed so they can be used for holding panel elements. The
Price
$10.63
price per set
excl. tax
set
This product cannot be ordered at the moment.

Ships Same Day if Ordered By 3 p.m MST Monday – Friday! 

Description
Mitre-Fastening Sets are suitable for connecting two aluminum extrusion profiles at an angle. They are used primarily when constructing frame elements and panel edging. The profile grooves facing each other inside the frame remain unobstructed so they can be used for holding panel elements.

The position of the clamping pins at right angles to the cut profile edge generates particularly high clamping forces on the fastening elements. The clamping screws are accessed from the side of the profile frame.

Mitre-Fastening Set 8
A mitred Profile 8 (at any angle γ between 30° and 90°) is screwed to the side of a Profile 8.

Note: Despite the optimized design, the flow of forces across the inclined contact faces of the profiles is such that only part of the pretension of the screw connection is utilized. Mitre connections therefore have a lower load bearing capacity than other, right-angled profile connections (Standard-Fastening,
Universal-Fastening or Automatic-Fastening Set).
Mitre-Fastening Sets should therefore not be used for constructing basic frames and safety-related parts that are subject to high loads.


Using Mitre-Fastening Set 8:
1. Mitre the profile at an angle γ.
2. Drill a counterbore of diameter 14.2 mm (Step Drill Art. No. 0.0.492.60) for the fastener sleeve in the side of the mitred profile (use of a drilling jig (Art. No. 0.0.493.72, Section 9.2 Jigs and Tools) is recommended).
3. Drill a 9 mm dia. hole in the end face of the mitred profile (use of a drilling jig (Art. No. 0.0.493.71, Section 9.2 Jigs and Tools) is recommended). The minimum drilling depth is 12 mm.
4. Insert the T-Slot Nut into the profile groove of the continuous profile to which the mitred profile is connected and screw in the clamping pin until the mark around the perimeter is level with the profile surface.
5. Insert the fastener sleeve into the mitred profile and fit the assembly over the clamping pin.
6. Drive the grub screw M10 into the fastener sleeve and tighten the profile connection (M = 15 Nm).
7. Fit the Cap onto the fastener sleeve.


 Set Includes:
 Clamping pin M8x28.5, St, bright zinc-plated
 Sleeve with bore, St, bright zinc-plated
 Grub screw M10, St, bright zinc-plated
 T-Slot Nut V 8 St M8, bright zinc-plated
 Cap, PA grey 

Reviews (0)
There are no reviews yet.
    Loading
    Loading